基于相关性分析的PCBA热力学模型修正

目的精确且高效地对印制电路板组件热力学模型进行修正。方法采用基于拉丁超立方抽样试验设计和Speraman等级相关系数计算公式的相关性分析方法,找出电子产品热仿真试验中对元器件表面温度值影响较大的输入参数,然后进一步分析得出输入与输出之间的函数关系。在此基础上给出印制电路板组件(PCBA)热力学模型修正的一般方法流程。最后利用该方法对某航空电子产品中一块PCBA的热力学模型进行修正。结果修正结果较精确且只调用2次有限元软件。结论该热模型修正方法具有较高的精确性和高效性,可推广用于工程实践。     

对氯气校正法测定高氯废水化学需氧量的方法研究

氯气校正法(HJ/T70-2001)是测定高氯废水化学需氧量的国标方法,为了减少样品测定过程带来的环境污染,研究在不改变HJ/T70-2001氧化体系及测试条件的情况下,将取样体积由20 mL减半为10 mL,试剂的使用量相应减半,对方法的检出限、相对误差、相对标准偏差等指标进行验证。结果表明,该方法的检出限符合要求,准确度较高,精密度较好,可用于高氯废水化学需氧量的测定。     

精细化工固定源废气采样时机的选择探讨

以某医药企业某产品生产过程为实例,综合各工段生产步骤、时间、废气产生情况及估算的污染物浓度等因素,绘制各污染因子排放规律图,从而确定各污染因子排放浓度(排放量)最大的1 h为最佳采样时机。     

生物气溶胶采样技术研究进展

介绍了沉降法、撞击法和静电场吸附法等3种常见生物气溶胶采样技术的基本原理及各自的优缺点,指出其发展趋势为建立复合式、大流量联合采样技术及小活性粒子的采样技术,实现生物气溶胶的快速自动化采样.     

大体积水中痕量POPs的联动采集装置及其性能评价

天然水体中的痕量持久性有机污染物(POPs)的定量分析通常需要采集大体积水样.针对大体积水样在过滤和吸附富集过程中滤膜易堵塞且耗时费力的缺点,研制了一种固液分离过滤-吸附富集联动装置.该装置主要由粗过滤器、离心分离屏、倒置微孔过滤器、固相吸附柱、流速控制阀和真空泵组成.与传统的滤膜过滤方式相比,其过滤效率提高了约1.5...     

Determination of 15 phthalate esters in air by gas-phase and particle-phase simultaneous sampling

Based on previous research, the sampling and analysis methods for phthalate esters (PAEs) were improved by increasing the sampling flow of indoor air from 1 to 4 L/min, shortening the sampling duration from 8 to 2 hr. Meanwhile, through the optimization of chromatographic conditions, the concentrations of 9 additional PAE pollutants in indoor air were measured. The optimized chromatographic conditions required a similar amount of time for analysis as before, but gave high responsivity, the capability of simultaneously distinguishing 15 kinds of PAEs, and a high level of discrimination between individual sample peaks, as well as stable peak generation. The recovery rate of all gas-phase and particle-phase samples of the 15 kinds of PAEs ranged from 91.26% to 109.42%, meeting the quantitative analysis requirements for indoor and outdoor air sampling and analysis. For the first time, investigation of the concentration levels as well as characteristics of 15 kinds of PAEs in the indoor air from four different traffic micro-environments (private vehicles, busses, taxis and subways) was carried out, along with validation of the optimized sampling and analytical method. The results show that all the 9 additional PAEs could be detected at relatively high pollution levels in the indoor air from the four traffic micro-environments. As none of the pollution levels of the 15 kinds of PAEs in the indoor air from the 4 traffic micro-environments should be neglected, it is of great significance to increase the types of PAEs able to be detected in indoor air.     

A soil sampling intercomparison exercise for the ALMERA network

Soil sampling and analysis for radionuclides after an accidental or routine release is a key factor for the dose calculation to members of the public, and for the establishment of possible countermeasures. The IAEA organized for selected laboratories of the ALMERA (Analytical Laboratories for the Measurement of Environmental Radioactivity) network a Soil Sampling Intercomparison Exercise (IAEA/SIE/01) with the objective of comparing soil sampling procedures used by different laboratories. The ALMERA network is a world-wide network of analytical laboratories located in IAEA member states capable of providing reliable and timely analysis of environmental samples in the event of an accidental or intentional release of radioactivity. Ten ALMERA laboratories were selected to participate in the sampling exercise. The soil sampling intercomparison exercise took place in November 2005 in an agricultural area qualified as a “reference site”, aimed at assessing the uncertainties associated with soil sampling in agricultural, semi-natural, urban and contaminated environments and suitable for performing sampling intercomparison. In this paper, the laboratories sampling performance were evaluated.     

A device for sampling the mud‐water interface in eutrophic lakes and bogs for residue analysis

Abstract

A tubular device has been developed making it possible to obtain layered samples of loosely aggregated, flocculent material from bogs or eutrophic lakes. The samples are up to 50 cm long and 15 cm in diameter. The sampler is free from protuberances and intact, layered samples can be taken. The tubular part of the sampler is about 85 em long, the walls of the lower 25‐cm portion harbouring a pneumatic closing mechanism which is controlled from above the water surface. An extendible handle for manipulating the sampler and for guiding it into place, is fastened to the upper end of the sampling tube. The performance and the operation of the sampler in the field are described.     

Enhancing the productivity and multifunctionality of traditional farming in Latin America

SUMMARY

An assessment is made of various grassroots development initiatives in Latin America which show that agroecological technologies can bring significant environmental and economic benefits to small farmers and rural communities in the region. Examined initiatives offer new ways of enhancing the multifunctional attributes of traditional agriculture through greater per unit area productivity and environmental services obtained in complex, integrated agroecological systems that feature many crop varieties, together with animals and trees. If such experiences were to be scaled up, multiplied, extrapolated, and supported in alternative policy scenarios, the gains in food security and environmental conservation would be substantial. The challenge now is to mobilize science, institutions and the right policies to increase the productivity of smallholder farming systems, while preserving the resource base and at the same time empowering local communities.     

Particle size distribution of airborne Aspergillus fumigatus spores emitted from compost using membrane filtration

Information on the particle size distribution of bioaerosols emitted from open air composting operations is valuable in evaluating potential health impacts and is a requirement for improved dispersion simulation modelling. The membrane filter method was used to study the particle size distribution of Aspergillus fumigatus spores in air 50 m downwind of a green waste compost screening operation at a commercial facility. The highest concentrations (approximately 8 × 10⁴ CFU m⁻³) of culturable spores were found on filters with pore diameters in the range 1–2 μm which suggests that the majority of spores are emitted as single cells. The findings were compared to published data collected using an Andersen sampler. Results were significantly correlated (p < 0.01) indicating that the two methods are directly comparable across all particles sizes for Aspergillus spores.